MDH
apl tablegantryjogx
Magnus_VLF
This NVS parameter holds the table X-axis jog offset to center gantry detect
sensor on the tab (mm). This value is used by the firmware when searching
for the picker gantry. The table moves in the X-axis until the picker gantry
is first detected. The table then stops and jogs the distance specified by
this parameter before engaging the picker gantry locks. This parameter can be
checked or calibrated by using the "apl gantry search" command.
This parameter is available.
10.000 [mm]
Please issue the appropriate monitor command to determine this parameter's minimum and maximum values.
17-Aug-2006
Created
Normal
..\..\ShowAllErrors.htmFirmware 1 Error Index
..\..\ShowAllCommands.htmFirmware 1 Command Index
..\..\ShowAllParameters.htmFirmware 1 Parameter Index